Cart 0

Matek 5 in 1 LED & Power Hub V3 Advanced PDB

RM 37.00

PDBs are becoming smarter and smarter - the Matek 5 in 1 LED & Power Hub V3 PDB is no exception. Featuring both 5V 3A and 12V 500mA BECs, a 5V LED controller, lost model finder and low voltage alarm - the new V3 PDB is now comprised of 2oz copper for even greater current carrying capability.

When running a 4-6S LiPo, the BEC can output 12V to power cameras and video transmitters. The built in 5V LED light controller can be toggled through three flashing modes (constant, slow or fast flash).

The buzzer on board can be triggered via a switch on your transmitter to act as a lost model finder in the event of an unexpected landing and can also act as a low voltage alarm to alert you that it's time to change batteries - the LEDs will also flash to remind you.



- Input: 3-6S (9-26V DC)
- 1 Battery input & 4 ESC outputs
- 4 pairs 5V LED light outputs
- Regulated 5V & 12V outputs
- LED power indicators (5V & 12V outputs)
- Low voltage alarm setting indicators
- Dimensions: 46x36x6mm
- Weight: 9g
- Mounting holes: 30.5mm square spacing (Naze32, CC3D, etc.)



- 2oz copper
- 4 layer PCB
- 20A continuous current per ESC
- 25A burst current per ESC

5V BEC:-
- Designed for RX, FC, OSD & Servos
- DC/DC synchronous buck regulator
- Voltage: 5V +/- 0.1VDC
- 3A continuous current
- Short circuit protection (10 seconds/minute)

12V BEC:
- Linear regulator - very low noise
- Designed for cameras and VTX
- Voltage: 12.0 +/- 1.3VDC (4-6S operation)
- Continuous current: 500mA @16V IN / 250mA @24V IN

LED Light Controller / Lost Model Finder:
Assign AUX channel to three pos. switch:
- Middle position: OFF (1400-1600)
- High position: LED ON or flash (1700-2000)
- Low position: Beep & LED flash (1000-1300)

Low Voltage Alarm:
- Low voltage selector (3.4V, 3.5V or 3.6V)



- 5 in 1 v3 PDB
- Nylon mounting fixtures
- 100mm servo cable
- Manual

Customer Comments

Author/Date Rating Comment